At present, cutter suction dredger is a kind of ship which is widely used in beach dredging project. Its working process of dredging, transporting and unloading can be completed continuously at one time. It is a kind of dredger with high efficiency and low cost, and a good underwater excavation machine. In this issue, we will learn about the details of the equipment operation.
1. When the cutter suction dredger stops, the sand in the hopper should be less than 1 / 2, and slowly lift the boom until the underwater quadrilateral wheel comes out of the water. There is no sand in the hopper, then stop the front diesel engine, and then stop the rear diesel engine.
2. In case of strong wind, about level 5 or above, please stop the cutter suction dredger temporarily in case of equipment failure, and stop the machine when repairing or replacing parts. To avoid personal injury.
3. Cutter suction dredger should be filled with lubricating oil frequently and maintained. In particular, the bolts of the hopper screw and chain pin, the butt plate of the water quadrilateral wheel, the reducer and the underwater quadrilateral wheel must be well fastened. Make sure to add lubricating oil to the rotating place. When the ship is in flood season or suspended, it should be tied in a firm place to prevent the dredger from being washed away or causing improper losses.
The above is the detailed introduction of cutter suction dredger when it stops working. It is necessary to strictly inspect the equipment and carry out routine maintenance regularly. If you have other questions, you can leave a message on the website. Thank you for reading.